Binding a radiolink to my drone.
« on: June 28, 2017, 04:07:12 pm »
I'm having trouble binding my radiolink to my drone with my r7eh receiver.any help would be nice thankyu
« Last Edit: June 28, 2017, 04:50:28 pm by f5soh »

Re: binding a raidolink to my drone.
« Reply #1 on: June 28, 2017, 04:10:48 pm »
Is your receiver configured for PPM, SBus, or normal (PWM)?
Did you answer this correctly (matching) when you ran the setup wizard?

Also, USB does not give power to the receiver.  You must have the flight battery plugged in for the receiver to get power.  Also, some ESCs don't have BECs and so you may need to have a BEC.

Re: binding a raidolink to my drone.
« Reply #2 on: June 28, 2017, 04:38:04 pm »
were do if ind these ppm,sbus, or normal pwm an I have a batt pluged in

Re: binding a raidolink to my drone.
« Reply #3 on: June 28, 2017, 04:47:19 pm »
its set for pwm had brain frezz sorry, is this right.

f5soh

  • *****
  • 3875
    • LibrePilot
Re: Binding a radiolink to my drone.
« Reply #4 on: June 28, 2017, 04:48:08 pm »
Seems it depends in how your receiver is configured, if R7EH-S look attached manual.

Preferred input will be Sbus, connected to the MainPort



Or PPM connected like this, assuming you have a CC3D:







Re: Binding a radiolink to my drone.
« Reply #5 on: June 28, 2017, 10:39:38 pm »
I do have bce. an still having a problem with linking any thing eles.

Re: Binding a radiolink to my drone.
« Reply #6 on: June 28, 2017, 11:25:11 pm »
There are several things you must get correct:
- The transmitter must be bound to the receiver.  See your radio instructions.
- The receiver output signal type (PWM, PPM, SBus) must be set to what you want.  See your radio instructions.
- The receiver must be connected to the correct port in the FC.  Different port is required for different receiver output signal type.
- You must tell the LP setup wizard which receiver output signal type you are using.