LibrePilot Forum
General Category => General Discussion => Topic started by: hunter12 on June 28, 2017, 04:07:12 pm
-
I'm having trouble binding my radiolink to my drone with my r7eh receiver.any help would be nice thankyu
-
Is your receiver configured for PPM, SBus, or normal (PWM)?
Did you answer this correctly (matching) when you ran the setup wizard?
Also, USB does not give power to the receiver. You must have the flight battery plugged in for the receiver to get power. Also, some ESCs don't have BECs and so you may need to have a BEC.
-
were do if ind these ppm,sbus, or normal pwm an I have a batt pluged in
-
its set for pwm had brain frezz sorry, is this right.
-
Seems it depends in how your receiver is configured, if R7EH-S look attached manual.
Preferred input will be Sbus, connected to the MainPort
(https://librepilot.atlassian.net/wiki/download/attachments/2818090/CC3D_Sbus.png)
Or PPM connected like this, assuming you have a CC3D:
(https://librepilot.atlassian.net/wiki/download/attachments/2818090/CC3D_PPM_Oneshot.png)
-
I do have bce. an still having a problem with linking any thing eles.
-
There are several things you must get correct:
- The transmitter must be bound to the receiver. See your radio instructions.
- The receiver output signal type (PWM, PPM, SBus) must be set to what you want. See your radio instructions.
- The receiver must be connected to the correct port in the FC. Different port is required for different receiver output signal type.
- You must tell the LP setup wizard which receiver output signal type you are using.