Lando

  • *
  • 7
CC3D Mess-up/Question, please help!
« on: February 02, 2018, 09:23:16 am »
So,
This is my first racing quad purchased ready to fly with a cc3d. After plugging it into LibrePilot and updating the chip i realized my transmitter (ppm) couldn't communicate with the cc3d. So after trying every input method on the configure hardware screen, i eventually switched the usb telemetry off and moved telemetry from USB HID Port to USB VCP Port. Rebooted the chip and now cant get telemetry and I cant upgrade & erase.

If some one has done the same thing please help!! thank you so much   

Re: CC3D Mess-up/Question, please help!
« Reply #1 on: February 02, 2018, 06:42:24 pm »
Unplug battery.  Unplug USB.  Go to Firmware page and press Rescue, then plug in USB, then after a few seconds, press Safe Boot.  That boots up in default settings.  Change what broke it.  Reboot normally.
« Last Edit: February 02, 2018, 10:18:55 pm by TheOtherCliff »

Lando

  • *
  • 7
Re: CC3D Mess-up/Question, please help!
« Reply #2 on: February 02, 2018, 07:56:51 pm »
You are a gentlemen and a scholar. Thank you so much!

gitit20

  • *
  • 50
  • If it will fly I will crash it.
Re: CC3D Mess-up/Question, please help!
« Reply #3 on: February 03, 2018, 09:17:16 am »
He knows all  8)
Do the best you can It's all you can do.

Re: CC3D Mess-up/Question, please help!
« Reply #4 on: February 03, 2018, 07:32:25 pm »
Laurent (@f5soh) knows about more things than I do.  :)
« Last Edit: February 03, 2018, 07:37:42 pm by TheOtherCliff »