LibrePilot Forum
General Category => General Discussion => Topic started by: Lando on February 02, 2018, 09:23:16 am
-
So,
This is my first racing quad purchased ready to fly with a cc3d. After plugging it into LibrePilot and updating the chip i realized my transmitter (ppm) couldn't communicate with the cc3d. So after trying every input method on the configure hardware screen, i eventually switched the usb telemetry off and moved telemetry from USB HID Port to USB VCP Port. Rebooted the chip and now cant get telemetry and I cant upgrade & erase.
If some one has done the same thing please help!! thank you so much
-
Unplug battery. Unplug USB. Go to Firmware page and press Rescue, then plug in USB, then after a few seconds, press Safe Boot. That boots up in default settings. Change what broke it. Reboot normally.
-
You are a gentlemen and a scholar. Thank you so much!
-
He knows all 8)
-
Laurent (@f5soh) knows about more things than I do. :)