tmohr

  • *
  • 3
Position Hold leads to configuration error
« on: November 06, 2017, 08:50:03 pm »
Hello,

I have a Revolution with GPS attached on FlexiPort.
The GPS has no Fix at the moment but the Revo receives data, all as expected.

I have set 3 flight modes and when i select Position Hold and save it, it shows me "configuration error" in GCS.

What do i do wrong?


Thanks for hints,
Torsten.

Re: Position Hold leads to configuration error
« Reply #1 on: November 06, 2017, 08:54:46 pm »
Home location must be set.

You must be using INS13 (Attitude->Settings->AttiEstAlgo)

You should have an aux mag (GPS/mag) installed correctly configured and calibrated

tmohr

  • *
  • 3
Re: Position Hold leads to configuration error
« Reply #2 on: November 07, 2017, 10:26:03 pm »
Thanks for your hint.  I have set INS13 and calibrated the sensors.
Still, the copter won't arm, i guess it needs a valid GPS position?  Even though the actual mode is Stabilized1?


Best regards,
Torsten

Re: Position Hold leads to configuration error
« Reply #3 on: November 08, 2017, 04:54:21 am »
After doing everything listed above, when using INS13, it must have green GPS and green mag for ATTI and STAB to go green and to allow arming.