Throttle not recognized in transmitter setup wizard
« on: February 16, 2017, 01:04:59 am »
While trying to do a setup of my CC3D in the setup wizard, I was going through the transmitter part and ran into a problem. The instructions said to move the throttle stick, and I did but it didn't detect it. Does anyone know why this is happening? I have a D4r-ii receiver and a Taranis X9D Plus transmitter. The receiver is in PPM mode and is bound with the transmitter.


  • *****
  • 4572
    • LibrePilot
Re: Throttle not recognized in transmitter setup wizard
« Reply #1 on: February 16, 2017, 07:29:08 am »
Hi, welcome.

No need to start the TX wizard, you should see some receiver activity before start.

Double check the input used in Hardware page, should be PPM_Pin8 and signal wire used is pin8.

Remember every change in hardware tab need a reboot : remove all the power from the board and connect again.
Be sure you added the jumper and connected the signal wire to the right receiver port.