« previous next »
Pages: [1]
*

DocHardinger

  • ***
  • 139
Black Rhino GCS with 16.09 RC2 Firmware
« on: December 13, 2016, 10:39:43 am »
Can i use Black Rhino GCS with 16.09 RC2 Firmware on my board without issues?
Cause  i made some changes in the 16.09 RC2 firmware because of wrong Baro. Just needed to change some lines of sensor reading in sensors.c
Otherwise i need to add these changes to the Firmware in Black Rhino and recompile it...And just uninstalled linux environment :-)
Logged
Hardware: F450 Frame--Revolution Board--EMax 2213-935kv--BullTec 30A Opto--5000mAh 3S 30C LiPo--NEO M8N GPS+MAG--Fr Sky Taranis Plus + OPLink Mini
Addon: sj5000x + two axis gimbal + minimosd + eachine VT + easycap
Software: Black Rhino, LP2GO
*

hwh

  • *
  • 1018
Re: Black Rhino GCS with 16.09 RC2 Firmware
« Reply #1 on: December 13, 2016, 11:46:11 am »
You probably can.  If it works, it works.  :)

The main reason you have to match GCS and firmware versions is because UAVObject IDs sometimes change between releases.  I don't think any have changed since RC2.
Logged
Pages: [1]
« previous next »