« previous next »
Pages: [1]
*

TangoEchoAlpha

  • *
  • 18
Stepper motor control?
« on: May 21, 2016, 09:51:52 pm »
I've got a gimbal that is controlled with stepper motors but the Revolution only has connections for servo motors. Is there anyway control stepper motors with the Revolution board?

If that's not possible, I may be able to modify the gimbal to use servos instead.
Logged
*

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Stepper motor control?
« Reply #1 on: May 21, 2016, 09:56:06 pm »
Stepper motor are not supported.
This output type should need 3 outputs per motor and some fet/driver module for that.
Logged
*

TangoEchoAlpha

  • *
  • 18
Re: Stepper motor control?
« Reply #2 on: May 21, 2016, 10:02:00 pm »
Quote from: f5soh on May 21, 2016, 09:56:06 pm
Stepper motor are not supported.
This output type should need 3 outputs per motor and some fet/driver module for that.

Alright thanks. Servo motors it is then.
Logged
Pages: [1]
« previous next »