[TangoEchoAlpha]

I've got a gimbal that is controlled with stepper motors but the Revolution only has connections for servo motors. Is there anyway control stepper motors with the Revolution board?

If that's not possible, I may be able to modify the gimbal to use servos instead.

[f5soh]

Stepper motor are not supported.
This output type should need 3 outputs per motor and some fet/driver module for that.

[TangoEchoAlpha]

Stepper motor are not supported.
This output type should need 3 outputs per motor and some fet/driver module for that.

Alright thanks. Servo motors it is then.