[Thrasher]

say what?
F4, mag, baro.
as always details are kinda sketchy, and sure looks like a lot of ports/connections

FWIW, commenter says it IS a revo and works in GCS 15.05.02

http://www.banggood.com/OpenPilot-Mini-CC3D-Revolution-Flight-Controller-For-FPV-Multicopter-5g-p-1018903.html?p=LI16170938632012117U

[liftbag]

say what?
F4, mag, baro.
as always details are kinda sketchy, and sure looks like a lot of ports/connections

FWIW, commenter says it IS a revo and works in GCS 15.05.02

http://www.banggood.com/OpenPilot-Mini-CC3D-Revolution-Flight-Controller-For-FPV-Multicopter-5g-p-1018903.html?p=LI16170938632012117U

I'm flying with this board, and it's fine. All works properly and the baro sensor is ok 

[Thrasher]

I'm flying with this board, and it's fine. All works properly and the baro sensor is ok 

so it IS a revo nano clone then?

[Brian]

I'ts not really a clone, since it's laid out very differently, and it has the same sensors as the original Revo, but it is a very nice board, and seems to be constructed well.

[liftbag]

I'm flying with this board, and it's fine. All works properly and the baro sensor is ok 

so it IS a revo nano clone then?

Not a nano, it's a revolution redesigned.

[rotary65]

Revo,  but seemingly without the integrated 433MHz RF module.

[f5soh]

If you want Oplink you should add the "air" oplink.
http://www.banggood.com/Openpilot-OPLINK-Mini-Radio-Telemetry-AIR-And-Ground-For-MINI-CC3D-Revolution-p-1018904.html

[liftbag]

Revo,  but seemingly without the integrated 433MHz RF module.

There is a dedicated port for the OPLink Air module, so you can have main and flexi ports free to use with other stuff.
The board is recognized as a full revolution, but the OPLink section is grayed, unless you connect the OPLink Air modem.

[daveapplemotors]

I want to do autonomous flight with an HK250gt CP helicopter. I have two of them flying well with CC3D nano boards. 

This BG Revo Nano board is good, right. And I don't want FPV but I do want satellite communications, right? Please, point me in the right direction for my sensors that I will need, thanks.

http://www.banggood.com/OpenPilot-Mini-CC3D-Revolution-Flight-Controller-For-FPV-Multicopter-5g-p-1018903.html?p=LI16170938632012117U

[TheOtherCliff]

Not related to Nano. 

I understand that that is a good one that acts like a Revo but does not have telemetry unless you buy "OpLink AIr" in addition.