Parris

  • *
  • 48
Revo and XY7000S receiver .
« on: January 25, 2016, 09:37:13 pm »
I have two boxes full of parts in my boneyard . Mainly HiSky and Spektrum stuff . I told one of the neighbor kids I'd build him a park flyer quad if I had most of the parts and didn't have to buy too much to get it into the air .
 My question is this :
Will an XY7000S receiver work on a CC3D or Revo ?
I'll be using 3s 11.1v and I know the XY7000S are rated around 5 V . Does that matter ? Isn't the CC3D or Revo receiver output around 5 V to begin with ?


              Thanks,

                    Parris
Parris

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Revo and XY7000S receiver .
« Reply #1 on: January 25, 2016, 10:58:15 pm »
You may need to power the board via the Output servo connector, generally the +5v is provided by the BEC from one Esc.

In others setup, the +5v comes from a stepdown / regulator.

But never power directly the board with a 3S battery or your connected receiver got also 12.6V at full charge !

Parris

  • *
  • 48
Re: Revo and XY7000S receiver .
« Reply #2 on: January 26, 2016, 05:13:01 pm »
Thanks f5soh .
I'll buy a couple 12v to 5v regulators, ( dist. boards ) . If I have to do any filtering I'll use the 3.7v contact point described in the Spektrum DSM2/DSMX set-up pages in the Wiki. I won't be using a satellite receiver , just a XY7000S only , so I hope I can just plug in and configure .

                                                  Parris
Parris

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Revo and XY7000S receiver .
« Reply #3 on: January 26, 2016, 07:54:07 pm »
If a DSM sat directly connected to board: need a small adapter or wire to sbl pad for 3.3v

If normal receiver, no issue with +5v, some receivers allow higher voltages also.