nabreu

  • *
  • 23
CC3D changes to Basic Configuration
« on: January 25, 2016, 06:25:42 pm »
Hi!

I noticed today that with the CC3D connected to the PC, i check the Use Advanced Configuration tab and change the values with no problem. I also can save them. But when armed, the board reset´s to Basic Configuration.

Is this normal ?

I´m trying to use EasyTune and got it setup but during flight, i can´t seam to see any effect when using the knobs and i was wondering if it´s because of this

f5soh

  • *****
  • 4572
    • LibrePilot
Re: CC3D changes to Basic Configuration
« Reply #1 on: January 25, 2016, 06:35:36 pm »
Advanced / Basic tab are two GCS display options, this option is not stored onboard.

Did you select the used pid bank ?
TxPID tab screenshot ?

nabreu

  • *
  • 23
Re: CC3D changes to Basic Configuration
« Reply #2 on: January 26, 2016, 12:15:41 am »
Screenshots attached. I think that maybe the mixer is wrong... I used at 90% all sliders but dropted to 75% seams better. At least i have the impression that if i lower the knobs on txpid the Hex gets softer. but very lightly. Maybe is my impression.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: CC3D changes to Basic Configuration
« Reply #3 on: January 26, 2016, 12:30:38 am »
Please remove the TPS when you use the EasyTune or reactions can be hidden.
You can increase the lower/upper value that move tuning range and see what appends.

whats the size/weight of this Hexa ?


nabreu

  • *
  • 23
Re: CC3D changes to Basic Configuration
« Reply #4 on: January 26, 2016, 09:15:13 am »
Hi

It's an RD290 With t-motors 2206 2000kv and runing GF5045 BN

It's about 750g with battery and camera

f5soh

  • *****
  • 4572
    • LibrePilot
Re: CC3D changes to Basic Configuration
« Reply #5 on: January 26, 2016, 10:26:04 am »
Try increasing values,
Remove TPS,
Fly FPV and do some acro

Be sure the bank selected in TxPID (bank1) matches the bank used in Flight Modes tab.