LibrePilot Forum
Development => GCS General => Topic started by: nabreu on January 25, 2016, 06:25:42 pm
-
Hi!
I noticed today that with the CC3D connected to the PC, i check the Use Advanced Configuration tab and change the values with no problem. I also can save them. But when armed, the board reset´s to Basic Configuration.
Is this normal ?
I´m trying to use EasyTune and got it setup but during flight, i can´t seam to see any effect when using the knobs and i was wondering if it´s because of this
-
Advanced / Basic tab are two GCS display options, this option is not stored onboard.
Did you select the used pid bank ?
TxPID tab screenshot ?
-
Screenshots attached. I think that maybe the mixer is wrong... I used at 90% all sliders but dropted to 75% seams better. At least i have the impression that if i lower the knobs on txpid the Hex gets softer. but very lightly. Maybe is my impression.
-
Please remove the TPS when you use the EasyTune or reactions can be hidden.
You can increase the lower/upper value that move tuning range and see what appends.
whats the size/weight of this Hexa ?
-
Hi
It's an RD290 With t-motors 2206 2000kv and runing GF5045 BN
It's about 750g with battery and camera
-
Try increasing values,
Remove TPS,
Fly FPV and do some acro
Be sure the bank selected in TxPID (bank1) matches the bank used in Flight Modes tab.