Min/Max input values not as expected
« on: June 29, 2018, 07:24:04 pm »
   This is not really a problem, because I see no ill effects, just something I'm curious about.

   Most Tx/Rx combinations generate channel values from roughly 1000 to 2000 microseconds, with insignificant variances.  Using my Hitec Aurora 9 Tx and a Hitec Optima Rx (PWM only), I do in fact see those ranges on the GCS input screen after calibration.  However, using the same Tx with a Hitec-compatible SBUS Rx, all the same channels show Min/Max ranges of about 438 to 1619.  Is this normal?  If so, what causes the unexpected range?

Setup is a Revo Mini and GCS 16.09 (heli setup).

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Min/Max input values not as expected
« Reply #1 on: June 30, 2018, 10:30:00 am »
Sbus ranges like this are normal and expected.

Re: Min/Max input values not as expected
« Reply #2 on: July 01, 2018, 05:41:51 pm »
Thank you.  Is that also the case with PPM receivers?

Re: Min/Max input values not as expected
« Reply #3 on: July 01, 2018, 06:46:19 pm »
PPM is just a set of PWM pulses in a row (timewise) on the same wire, so PPM pulse widths are the same as PWM pulse widths.