Nano OPLink Issue
« on: December 10, 2015, 02:29:17 pm »
Greetings LibrePilot Crew and Forum Members!

I have been having trouble connecting my Nano and OPLink modules to CGS.

Running 15.09
- Ran full Vehicle and Transmitter set up successfully
- Set up Nano to have OPLink on vehicle to connect via Flexiport and into FlexiPort of Flight OPLink
- Set up Flight OPLink per instructions in other posts on this forum
- Set up GCS USB connected OPLink per instructions in other posts on this forum
- Can see both OPLinks when connected directly to GCS via USB

ISSUE:
- Start GCS with OPLink Coordinator module connected via USB
- Start Nano with Flight OPLink Connected to Flexiport on Nano and Flexiport on OPLink and see 3 LED indicators on Flight OPLink and Green and Orange LED on GCS OPLink
- Do not see any bind indicators in GCS
- Do not receive any telemetry from Nano

What am I doing wrong?

Best Regards,
Subpixel

f5soh

  • *****
  • 4545
    • LibrePilot
Re: Nano OPLink Issue
« Reply #1 on: December 10, 2015, 03:43:07 pm »
Hi, welcome here.

Witch baudrate ? Try using 57600 baudrate.


Re: Nano OPLink Issue
« Reply #2 on: December 10, 2015, 06:45:46 pm »
f5soh,

THANKS!! That did the trick!  :D I am SO happy LibrePilot got off the ground. I was just starting to get into the hobby and finally acquired all my gear just as OP went down. I look forward to fun and flying now!

Cheers,
Subpixel

f5soh

  • *****
  • 4545
    • LibrePilot
Re: Nano OPLink Issue
« Reply #3 on: December 10, 2015, 07:28:09 pm »
Great :)