LibrePilot Forum
Development => Hardware => Topic started by: subpixel on December 10, 2015, 02:29:17 pm
-
Greetings LibrePilot Crew and Forum Members!
I have been having trouble connecting my Nano and OPLink modules to CGS.
Running 15.09
- Ran full Vehicle and Transmitter set up successfully
- Set up Nano to have OPLink on vehicle to connect via Flexiport and into FlexiPort of Flight OPLink
- Set up Flight OPLink per instructions in other posts on this forum
- Set up GCS USB connected OPLink per instructions in other posts on this forum
- Can see both OPLinks when connected directly to GCS via USB
ISSUE:
- Start GCS with OPLink Coordinator module connected via USB
- Start Nano with Flight OPLink Connected to Flexiport on Nano and Flexiport on OPLink and see 3 LED indicators on Flight OPLink and Green and Orange LED on GCS OPLink
- Do not see any bind indicators in GCS
- Do not receive any telemetry from Nano
What am I doing wrong?
Best Regards,
Subpixel
-
Hi, welcome here.
Witch baudrate ? Try using 57600 baudrate.
-
f5soh,
THANKS!! That did the trick! :D I am SO happy LibrePilot got off the ground. I was just starting to get into the hobby and finally acquired all my gear just as OP went down. I look forward to fun and flying now!
Cheers,
Subpixel
-
Great :)