rad2014

  • *
  • 14
Re: Acroquad 400
« Reply #15 on: September 03, 2017, 04:20:47 pm »
I haven't had problems with yaw servo. My biggest concern was 3S + 1000kv + 8" props = sluggish performance. I have to check if escs support 4S, to see if that makes difference, although the motors were already uncomfortably hot at 3S.

8" props and 1000Kv motor on you tricopter could be the problem - probably you dont have enough power. What is your AUW? Have you tried 10" props? Btw. high motor temperature can be caused by a bad tune.

mr_w

  • *
  • 147
    • LibrePilot
Re: Acroquad 400
« Reply #16 on: September 03, 2017, 04:38:41 pm »
Yes, I did try 10" too, but those motors did not have enough authority over them props. I just blame it on the motors. Poor quality. I have had same size motors, but different type (X2212) that performed so much better (on a different build - they came in as replacement for those A2212 which I reused on tricopter).