[Paolo]

Hi All,
I'm in a corner situation due to red light always on INPUT.
Never had problem on installation of DJI, TAROT XYZ, Gimbal from China
(not easy at all but i fund solution).
Using : GCS 15.09 version on CC3D Atom from Tarot, for 250FPV drone
Rx : Futaba R3008SB (test was made with two different rxR3008SB, how to avoid possible material error), Tx Futaba T10J, Engines and ESC properly installed
but no communication between Rx and radio, red light on Rx
and no way to link Tx to Rx.
I try to changes cable : no way
Changes computer : no solution
Changes Windows (XP, 8 and 10) but always red color
I tried (for each computer and each cable - imagine time and frustration)
to select Sbus on main port, PPM, PPM 8pin, PGW on receptor channel but always red light on INPUT and no communication between rx and radio.
Explanations on bubble appearing on red INPUT are not clear, and Health Status escape from my poor knowledge.
If someone can help me with simple explanation, it will be a Great Xmas Gift for me.
(french and italian language are wellcome)

Paolo from Rwanda ( Central Africa)

[f5soh]

Rx : Futaba R3008SB (test was made with two different rxR3008SB, how to avoid possible material error), Tx Futaba T10J, Engines and ESC properly installed
but no communication between Rx and radio, red light on Rx
and no way to link Tx to Rx.

Hi,

You need to find first whats wrong with your rc radio / receiver. Maybe need a bind ?
Red receiver led says there is no communication, nothing to do with config or cable between Rx and FC

[Paolo]

Perfetto - this open my eyes and i bind rX and tx.
It was logic, but after test and test and test, my head was a little confused.

Now all of parameters are green, easy link with Tx, easy parameters to introduces,
LibrePilot are a really great system.

Thanks again for this Big Xmas Gift,

from Paolo

[f5soh]

In all case of headaches, take time to cogitate 5minutes.

Enjoy