ViKiNGi

hi

i have kylin 250 and i updated firmware from openpilot to librepilot.

everything else went on but.


- quad nose orientation ia reversed.

when i point nose to ground, computer show it to sky (on librepilot gcs) and when i point nose to sky, it shows LB to ground.

what is wrong on conf?
« Last Edit: June 26, 2017, 09:23:25 am by ViKiNGi »

f5soh

  • *****
  • 4572
    • LibrePilot
Re: quad nose orientation
« Reply #1 on: June 25, 2017, 02:48:54 pm »
Hi,

You may need to adjust the virtual rotation in attitude tab if board is rotated.
https://librepilot.atlassian.net/wiki/display/LPDOC/CC+Attitude+Configuration

Be sure you didn't understand reversed from PFD view:
https://librepilot.atlassian.net/wiki/display/LPDOC/PFD#PFD-Troubleshooting

utoedter

  • ***
  • 170
    • Frickeln und mehr
Re: quad nose orientation
« Reply #2 on: June 25, 2017, 03:20:59 pm »
Check the board orientation and change if needed.


Rettet den Luftraum, esst mehr Vögel.

ViKiNGi

SOLVED: Re: quad nose orientation
« Reply #3 on: June 26, 2017, 09:22:50 am »
Hi,

I found resolution. So my old OpenPilot set Roll always to 180 degreed (default), but LibrePilot did not.. I fixed LB Attitude -> Rotate virtual attitude relative to board: Roll to that 180 degrees.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: SOLVED: LibrePilot / Quad nose orientation / horizon upside down
« Reply #4 on: June 26, 2017, 10:34:35 am »
OpenPilot or LibrePilot will reset the virtual rotation to 0,0,0 when board is erased, no difference between versions.