I have a HP Heli BatFly 250 Racer (same as a Eachine Racer 250) and have been struggling to setup the Quad and especially the RTF TX that was included with the Quad. After getting through the Quad Wizard (still have ESC calibration problems) I went to the TX Calibration Wizard.
The BatFly was still connected to the PS via USB, no battery connected, then turned on TX, attached battery to the Quad (to power up the Receiver). Started the TX Calibration Wizard and followed the direction on the screen, LibrePilot responded to moving Throttle up and down, then the Pitch up and down, then it took more then a minute for the Wizard to recognize I was moving Roll stick in uni-sense with the Wizard. However the Wizard never recognized the Yaw movement of the TX stick and I know that the radio gimbals work when I flew the BatFly previously.
What is going on? Since I had to bail from the Wizard, now the radio won't even ARM the motors, I've essentially got a Quad brick, thanks to LibrePilot.
Using LibrePilot SuperMoon Eclipse.