[mazevx]

Wich Input should i use? Same as ppm?
Sorry for that question...

[m_thread]

Do you mean on the Revo or on your receiver? I don't own a Graupner receiver so if it is that I'm not going to be to any help If its the Revo board you mean you can connect the serial cable from the receiver to either Main or Flexi port. Configure the ports in GCS and you should be fine.

[mazevx]

Yes i meant the revo, thanks i wasnt sure if its configurable as normal.

[mazevx]

Just tested sumD on revo mini, everythings working fine!
Receiver setup wizard performing well and gcs showing everything correct, so "thumbs up"
No flite test yet...tested on desk but that doesnt make a difference to me.

setup was:
FC: revo mini (banggod)
TX: Graupner MX20
RX: Graupner GR12L

[bozzo12]

hello,
 what's new since the last post?
I bought a gr12sh rx for use with cc3d, but is not a atom, of course, nothing works
it canot work if cc3d isn't an atom? or there are upgrage since?

thx

[f5soh]

Hi,

CC3D or CC3D Atom shares the same schematic.

Download the 16.09RC2 and try the Hott input in FlexiPort.
https://forum.librepilot.org/index.php?topic=2424.0

You can use the Vehicle Wizard as well and get the connection diagram in Summary page.
Wiring is the same as a SBus input.
https://librepilot.atlassian.net/wiki/display/LPDOC/CC+Hardware+Configuration#CCHardwareConfiguration-MainPortandFlexiPortserialcablepinout

[bozzo12]

ok, i go try it!!

[bozzo12]

great, it work fine!!!!