throttle pulsing problem
« on: October 10, 2016, 05:10:58 pm »
this i originally thoutght was my cc3d board so i replace that and im still getting my quad wont hold a consistent throttle it just throttlels on and off in puleses at no matter where i put the throttle stick it justs keeps going until i cut the throttle to min, im not sure what to do ive trouble shot a lot of things including the wireing and the possibility of a bad esc ive tested the each induvidually and they perform fine please help

signal goes fuzzy when throttle up
« Reply #1 on: October 10, 2016, 07:44:28 pm »
i have my qav running nicely so i put my fpv gear on i get great signal when just walking away but as soon as i throttle up it goes to shit

Re: throttle pulsing problem
« Reply #2 on: October 16, 2016, 10:01:51 am »
You may have selected an ESC mode that sends data faster than your ESCs will accept.
Try PWMSync ESC mode.

Re: signal goes fuzzy when throttle up
« Reply #3 on: October 17, 2016, 08:50:14 am »
Are you using the same battery for FPV and motors?
Other than that, it could be a loose connection that gets intermittent with vibration.