Transmitter setup wizard issues
« on: September 22, 2016, 12:51:03 pm »
I am tryin to setup my cc3d and during the transmitter setup wizard if isn't seeing my inputs. I move the throttle stick and that's good. Next it asks for roll. I move the stick and nothing. I can not get past that point. Also. During the main setup when it goes to activate the motors with the slider I get nothing. I am using 12a escs that came with the rjx caos 330 kit. Thanks. Please help.

hwh

  • *
  • 1018
Re: Transmitter setup wizard issues
« Reply #1 on: September 23, 2016, 02:37:51 am »
You didn't provide much detail but my first thought for both not working would be no power.  Was the battery connected when you were running the transmitter and motor tests?  USB only powers the cc3d itself, nothing else gets power from it.   And does the cc3d power up when the battery is connected without usb connected?

Re: Transmitter setup wizard issues
« Reply #2 on: September 24, 2016, 10:29:03 pm »
You must be careful to not move any stick except the one it asks for, that is the issue sometimes.

I would also test it by plugging a servo in to make sure the transmitter moves the servo with the stick in question.