Home
Help
Search
Login
Register
Programming Solder bheli esc
LibrePilot Forum
General Category
General Discussion
Programming Solder bheli esc
« previous
next »
Print
Pages: [
1
]
hawkview
33
Programming Solder bheli esc
«
on:
September 11, 2016, 09:38:13 am »
Hello librepilot folks
I have solder my esc straight to revo and would like to change the settings on the esc e.g turn on active damping.
Do I need to unsolder esc or can i just use my arduino jumper wires to program the esc in place or will I damage revo if I do this?
Thanks
Logged
hawkview
33
Re: Programming Solder bheli esc
«
Reply #1 on:
September 17, 2016, 09:07:34 pm »
Just in case anyone comes across this on a search.
The answer as of gcs 16 is no
It will not work you need to unsolder the signal wire to the esc, ground can stay connected
All flashed now with one shot working on a revo.
Logged
TheOtherCliff
4304
Re: Programming Solder bheli esc
«
Reply #2 on:
September 24, 2016, 08:20:59 pm »
This is something that is being worked on by a developer. I don't expect it in the coming 16.09 release? But I there is talk to have another release much sooner than a year from 16.09.
Logged
Print
Pages: [
1
]
« previous
next »