SBUS not responding
« on: October 31, 2015, 05:31:10 pm »
I had a perfectly flying and functional setup on OP Ragin Cajun and then flashed Libre keeping everything the same.

I can't get the receiver to be read for mapping radio controls.  I can take another CC3d and OP FW on the same setup and its reading the controls.

Help please?  Everything is setup as it should and bound.

Help Please!  Thanks!

cato

  • *
  • 341
Re: SBUS not responding
« Reply #1 on: October 31, 2015, 06:20:37 pm »
Hi,

is the non-working controller a CC3D? I set up LP 15.09 with a Hobbyking CC3D and two revos with no issue at all, all of them using S-Bus. Did you try to upgrade&erase and then set up everything freshly (you can save your setup before)?
Nighthawk 250, MT1806, 12A ESC OneShot125, Revo, M8n GPS, FPV
Cinetank MKII, Elite 2216, 30A Afro OneShot125, Revo Clone, M8N GPS

Re: SBUS not responding
« Reply #2 on: October 31, 2015, 09:59:35 pm »
yes it is a CC3d Controller, I did the exact upgrade as you do on OP.  Upgrade/Erase and ran through the wizard.  Its does everything else just fine. 

I literally can swap the rx to a OP setup CC3D and all works fine.

gonna re-upgrade/erase now.

Re: SBUS not responding
« Reply #3 on: October 31, 2015, 10:37:44 pm »
figured it out... was a bad cable apparently.... dumb me...

thanks!

cato

  • *
  • 341
Re: SBUS not responding
« Reply #4 on: November 01, 2015, 09:35:46 am »
good you could find the reason :)
Nighthawk 250, MT1806, 12A ESC OneShot125, Revo, M8n GPS, FPV
Cinetank MKII, Elite 2216, 30A Afro OneShot125, Revo Clone, M8N GPS