LibrePilot Forum
Development => GCS General => Topic started by: ATx RC Productions on October 31, 2015, 05:31:10 pm
-
I had a perfectly flying and functional setup on OP Ragin Cajun and then flashed Libre keeping everything the same.
I can't get the receiver to be read for mapping radio controls. I can take another CC3d and OP FW on the same setup and its reading the controls.
Help please? Everything is setup as it should and bound.
Help Please! Thanks!
-
Hi,
is the non-working controller a CC3D? I set up LP 15.09 with a Hobbyking CC3D and two revos with no issue at all, all of them using S-Bus. Did you try to upgrade&erase and then set up everything freshly (you can save your setup before)?
-
yes it is a CC3d Controller, I did the exact upgrade as you do on OP. Upgrade/Erase and ran through the wizard. Its does everything else just fine.
I literally can swap the rx to a OP setup CC3D and all works fine.
gonna re-upgrade/erase now.
-
figured it out... was a bad cable apparently.... dumb me...
thanks!
-
good you could find the reason :)