[cchavezpadky]

Hello, I am new to quads. This is my first build.
I have a CC3D Flight controller and a FrySky-D8R-II-Plus

Does anyone have a wiring scheme I could follow. I am not sure where to cable up my FC to the Receiver.

I appreciate any and all help and thank you in advance.

[f5soh]

Hi, welcome.

You should do the wiring like that:


Every connector position doesn't matter, the Tx Wizard will detect the activity while you move a specific stick/switch.

[cchavezpadky]

f5soh  Thank you for the reply.

I'm looking at my wire harness and the color code seems different, based on the picture.
Would you mind taking a second and helping me with pin position.
My harness -6 cables
This is the cable that came with the CC3D.

1- Black, Red, White  "3" wires
2- Red  "1" Wire
3- Purple "1" Wire
4- Green  "1" Wire
5- Yellow  "1" Wire
6- Black  "1" Wire


if I am hearing you correctly.

On the Receiver -
port 1 goes to cable harness (Black, Red, White)

2-6 can be in any order?

Thank you again

[hwh]

The order doesn't really matter but for convenience troubleshooting later they're usually connected in the same order they come off the other connector.

[cchavezpadky]

Thanks, going to give it a try tonight or tomorrow. Appreciate the help everyone.

[Nefer]

I just can get my flight mode switch working if keep channel five empty and connect last 2 wires in channel 6 and 7. I got same board and same receiver