kennyevo

  • ***
  • 101
MinOPOSD disappears on throttle
« on: April 11, 2016, 06:06:47 pm »
Hi!

I've configured my minoposd, it shows everything correctly, and it is connected to the rc input port. (i'm using oplink vehicle control)
When I want to take off, the screen flashes and the osd disappears, but If I use the transmitter without the osd it doesn't blink on throttle. (so I don't think that it's a interference with the motors (at least not on the 12v side).
Is it possible that the esc gives instabil voltage to the FC?
Should I use a Power modul?

Thanks in advance!

kennyevo

  • ***
  • 101
Re: MinOPOSD disappears on throttle
« Reply #1 on: April 14, 2016, 10:04:11 am »
Okay, it was the BEC's fault which is integrated in my ESCs. If I power the FC from a power modul everything is fine. (should have done that at the beginning)