Randy

  • *
  • 6
Position Hold
« on: April 04, 2016, 11:38:59 pm »
Hello, What does the vertical and horizontal PositionHoldOffset Do? Should i change from default that is [Horizontal 30m and Vertical 15m]?

Oulala69

  • *
  • 30
  • DIY 450 mini revo AIRGEAR 350 NEO-8N GCS 16.09-RC2
Re: Position Hold
« Reply #1 on: June 06, 2016, 04:27:26 pm »
Hi, my post will not help, as i am searching the meaning of those parameters...
If you find the answer, please telle me, i will do the same on my side

f5soh

  • *****
  • 4545
    • LibrePilot
Re: Position Hold
« Reply #2 on: June 06, 2016, 05:07:18 pm »
If you found where the values are, you can also look the tooltip:
Just put the mouse above Horizontal or Vertical uavo

Oulala69

  • *
  • 30
  • DIY 450 mini revo AIRGEAR 350 NEO-8N GCS 16.09-RC2
Re: Position Hold
« Reply #3 on: June 10, 2016, 01:23:08 pm »
Thank you very much for this Tip.
So, "stick sensitivity for position roam modes" and values in meters !
not clear for a french guy, but i am to curious  ;)

Re: Position Hold
« Reply #4 on: June 13, 2016, 05:05:55 pm »
It's my understanding that these are only used so the aircraft has a reference direction when switching into PH.  There are some settings that allow you to for instance make the yaw direction always correspond to the direction of flight so it is always flying with the nose forward.  In PH there is no "forward".  This gives it one in places where it is needed.

I have never seen a case where it needed to be changed.