[windycity]

Hello, I am trying to calibrate the controls for my quadcopter but it only responds to throttle and roll; or pitch and yaw; in other words it does not  recognize all four throttle/yaw/pitch/roll I'm using a Tactic 850 remote control and my quad is a Rise RXD250.  Could someone please advise?  I will be at the calibration screen where it prompts you to move each stick but I am never able to complete the whole set.  Is something wrong?  batteries on quad and tx are fully charged.  Thanks so much.

[f5soh]

Hi,

First at all you need some Input activity before starting the Tx wizard.
Take a look here about possible issues:
https://librepilot.atlassian.net/wiki/display/LPDOC/RC+Transmitter+Wizard#RCTransmitterWizard-FrequentlyAskedQuestions

Double check especially the input you choose in Hardware tab matches the wiring and receiver output.
See hardware pages, like this one for CC3D:
https://librepilot.atlassian.net/wiki/display/LPDOC/CC+Hardware+Configuration#CCHardwareConfiguration-ReceiverPort

Receiver activity is displayed at upper/right corner in Input tab :
https://librepilot.atlassian.net/wiki/display/LPDOC/Input+Configuration#InputConfiguration-RCInputTab