fpv's and a problem to get then working
« on: February 20, 2016, 06:07:12 pm »
I have gotten the OSD set and everything is tried and ready to so.

The problem exists with the RC OSD setup.  The CC3D has a minopd that is selected as a V2.2 item and has a MAVLink.  I also has a standard one that should also work.  Both will allow me to use the one after boot, move the Toggle switch and you enter the Setup screen. Pitch stick change parameter while Roll stick allow parameter/value adjustment.  At this point I can get the boot but not further.

I am stuck.