[rogdodger1]

I bought a full Revo kit from Bangood. The upgrader will not recognize the board. Other cc3ds are fine. Does anyone have any ideas? It is the same on Mac and Windows.

[f5soh]

What appends after a rescue ?

- hit Rescue button
- connect board


Led behavior after usb connect ?

[rogdodger1]

I get the same behaviour. The green light flashes twice for less than a second and then for about 2 secs, no other lights. It then times out and replies that no connect. I have another revo controller and it works perfectly.

Thanks for the help, any other ideas.

[f5soh]

Its a hardware issue, the green led (power) is directly connected to a regulator output and should never blink.

[rogdodger1]

Thanks guys, I had a bad board. Bang good replaced it and it works. Took some time though.

Thanks Again