[brand1068]

I have an F450 with Simonk 30a Speed controllers on a Futaba 7C and R617FS Rx

Ran it through the Vehical setup and the TX wizard but it wont arm unless i set it to always arm..

The Motor Channels are set to PWM 490hz both channels appear to respond to the TX when moved.

Assuming I'm doing something stupid - any ideas ?

Chris

[muchzill4]

Do you have any of the alerts in red on the flight data panel?
Did you try different arming settings? (switch vs yaw or what have you)

[f5soh]

Hi,

Check if you see any red alarm in your SystemHealth panel

The  [ ? ] can give more information.


You can also post your config file: File > Export UAV settings and attach .uav file here.

[brand1068]

Ok  - not sure why but set all the flight modes to manual thrust and that appears to have fixed it.

Have one issue with the motors but will start another post - thanks for your help