LED light and then operation
« on: June 18, 2019, 06:01:04 pm »
Hello everyone, I set up my cc3d and then when I prick my battery in the flash leds and go out. This group is the LED light that goes ahead, including the back of my large square, rsx 270mm, during my first experimental flight. (Flying in my garage) They start blinking. After that, they will flash when I pierce my battery and then Are there food items configured for LED lighting? I can't see anything in libreflight. Thank you. GDWBET

Re: LED light and then operation
« Reply #1 on: June 18, 2019, 06:16:41 pm »
If you are speaking about the LEDs that are part of the CC3D board (or extra WS2811 LED added with a wire cable), then if they go out (turn off) it usually means that the power to the CC3D has gone out.

Or maybe you are speaking of LEDs that were added by manufacturer on this drone that LibrePilot software does not know about?

If you can determine the kind of LED (usually simple LED or WS2811 LED) and where it connects to the CC3D, then maybe we can understand your problem better.  :)