Help with TxPID
« on: September 21, 2017, 06:32:15 pm »
Gents, I was able to set up and verify operation of the CC3D in Rate mode. Now. I want to take advantage of the TxPID, and I configured following readings and videos, but I cannot get results. I assigned a slider to CH 6, and I can see the input values, but the PID values in the stabilization screen do not change. Attached are some screen shots, that shows what do I have. I am using PWM for all channels, and I have updated the soft as suggested in Libre Pilot.
I think I am missing something, but after trying for two days different configurations I cannot figure out why what it should work, does not.

f5soh

  • *****
  • 3875
    • LibrePilot
Re: Help with TxPID
« Reply #1 on: September 21, 2017, 07:18:34 pm »
If you want something changing in Stabilization tab you may set some range, this means min and max values different in TxPID tab.

You can also use the EasyTune feature that allow some fixed coefficients, allowing change P and ID numbers at same time with one input.
Maybe do some tuning for Pitch and next, other session for Roll.