[MikeNH]

The ESCs on my LHI250 "X" kit quad are Emax Simonk 12amp. Why, after using the calibration wizard, are motors NW & NE (1&2) at 490Hz and the other two motors are 50Hz? I change them to 490Hz manually but I am trying to understand why Librepilot assigns the slower update rate to the SW & SE motors. I've searched for an answer but have not found one (at least that I can comprehend).

Thanks in advance for any information for this newbee.

[TheOtherCliff]

Output page.  Set all banks attached to all used outputs to 490.

[f5soh]

Why, after using the calibration wizard, are motors NW & NE (1&2) at 490Hz and the other two motors are 50Hz?

Assuming you are using a CC3D, here is the Output tab:



output 1, 2 and 3 uses the bank1 set to PWM-490Hz (green color code)
output 4 use the bank2 set to PWM-490Hz (cyan color code)

Others banks (3&4) are used for output 5 to output 10, in this quad example not used for motors.

[MikeNH]

I appreciate the replies. I am using a CC3D.

If then, I was flying a hexcopter with the with the same ESCs, then channels 1-6 would be recognized as 490 Hz?

Because I am using channel 5 as the Flight Mode switch, is it true to say there is no practical advantage to setting the Hz to 490?

Thank you.

[f5soh]

Look colors

Bank1 is output 1,2,3
Bank2 is output 4
Bank3 is output 5, output 7 + 8
Bank4 is output 6, output 9 + 10

Channel 5 as the Flight Mode switch has nothing to do with Outputs, just related to RC Inputs

If you really need a output running @50Hz with a hexacopter for some input/output mapping you need to connect some motors to the FlexiIO port and play with banks.
https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/2818090/CC+Hardware+Configuration#CCHardwareConfiguration-ReceiverPort

[MikeNH]

Thank you for the prompt replies and for all the great work on this Librepilot project.