[u2builder]

I am a newbie.  I set up a quad and everything went well except I get a RED Config alarm and a RED "?".  The notes indicate it might have something to do with GPS but I have a CC3D board, and don't have any flight modes that would appear to have anything involving GPS.  I am using 15.09 build and used it to update the board with the latest firmware (I think). 

What might I have done wrong.  Are there other things that could trigger these Alarms.

Thanks for any suggestions.

[f5soh]

Hi, welcome.

Please post your config file.
File > Export UAV Settings...

[u2builder]

Thanks.  Attached is UAV Settings.    I also included GCS settings just in case.

Hopefully you can advise me of where I went wrong. 

[f5soh]

You still have a "Manual" for Yaw stabilization, should be Rate or AxisLock

Go to Input tab > FlightMode settings

[u2builder]

Thanks!  Much appreciated! 

[u2builder]

It worked like a charm.  I am very excited.  I need to do a few more little things but hopefully I can test fly it soon.  I anm a builder at heart and it was interesting to put my little ZMR clone together. 

I have to say that the Libra Pilot software is really, really nice. It is well organized and graphically pleasing.  I love the fact that I can just connect up to the USB port and make changes without having to be a computer expert and worry about COM ports and Bootloaders and stuff like that.  Changing and saving things is super easy and clear.

I also appreciate the support here on this forum.  I had spent quite some time searching the internet for a solution, and f5soh solved it quicker than it took me to register on the site since I can never read those funky letters one has to enter.

Thanks.

Edit:  I did the "maiden" of the ZMR 250 today and I was very pleased with how it flew.

Thanks again.