[Jackbear]

I can't seem to access my minimosd menu. I have tried the throttle middle, yaw right, pitch forward with no success. I saw somewhere that is was due to a setting with the min and max of the sticks, but I cant find it now.Other than the "battery low" warning flashing, everything works fine. Any help would be greatly appreciated 

[f5soh]

You need to configure the channel toggle first:
https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup#MinOPOSDsetup-Channeltoggle
You can enter on Setup Screen just after boot using this channel toggle.

And change some refresh rates or the browsing/set is not so easy:
https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup#MinOPOSDsetup-Refreshrates

[Jackbear]

Thank you! i got it to toggle to the setup menu, but now I dont see where to set the values to turn off the low battery warning. In the setup, the battery warning is set at 0. It reads the correct voltage in the OSD, but the battery percentage flashes as 0%. Its frustrating missing the little things! LOL

[f5soh]

What flight controller and OSD firmware are you using ?

[Jackbear]

It's a Revolution board and a minimosd V 1.2 with kv mods. I have all data coming thru the flex io port

[f5soh]

So the sensor is connected to Revo board, and alarm comes from Revo ?
Maybe are you using a voltage only basic sensor ?
https://librepilot.atlassian.net/wiki/display/LPDOC/Configure+a+Current-Voltage+sensor#ConfigureaCurrent-Voltagesensor-DisableTIMEalarm

[Jackbear]

Thats correct. Its a voltage only basic sensor

[Jackbear]

And I did set the flight battery capacity to 0 as well

[f5soh]

How are the alarms in PFD / SystemHealth ? Something red ?

[Jackbear]

Greens across the board with the proper voltage reading in green as well

[f5soh]

Set the "battery warning" value in Setup screen to something real like 10.5 for a 3S

If the voltage is displayed correctly in OSD screen there is no reason to see "Batt low" alarm.

[Jackbear]

Im using a 4s, so I have it set at 13.6. It still says "Battery Low!", even though it shows 15.07 on the screen.

[f5soh]

Try if firmware attached fixes the "Batt low" alarm.

[f5soh]

Try also this one that should also use the battery alarms from Revo (warning / critical / error) and osd battery level you set in Setup Screen

[Jackbear]

I reflashed the board and did a clean reinstall and it works great! Thank you!