100mm brushed frame, what to do?
« on: October 03, 2016, 05:19:15 pm »
So I picked up a 100mm cc3d frame from bangpoop. Not sure how to configure the motors. tx input and everything else responds well. just not sure how to configure the motors..

http://www.banggood.com/Micro-CC3D-Open-Source-DIY-Brushed-Flight-Control-Board-for-720-8520-Coreless-Motors-p-1075214.html

hwh

  • *
  • 1018
Re: 100mm brushed frame, what to do?
« Reply #1 on: October 03, 2016, 05:45:55 pm »
Brushed motors are not officially supported.  f5soh worked out settings to make them work but the wizards and some of the other settings pages don't support it.

Someone got a brushed board working using f5soh's settings that I posted in the thread https://forum.librepilot.org/index.php?topic=1597.msg11639#msg11639    The board he used was essentially a cc3d with FETs on the output channels that he designed and built.

Re: 100mm brushed frame, what to do?
« Reply #2 on: October 04, 2016, 12:12:12 am »
Thanks for the reply, sounds like it may be possible. how do I get UavoBrowser?

hwh

  • *
  • 1018
Re: 100mm brushed frame, what to do?
« Reply #3 on: October 04, 2016, 01:40:50 am »
You already have it  :)

It's the left half of the system tab in GCS.