[@marc]

You should never set throttle value above 0 in failsafe mode. If failsafe triggers, something went wrong and you no longer have any control.
You do not want your props spinning in that case.

[D17E]

Try to start with a "clean configuration":

hi....
how to conect to the phone..?

[@marc]

how to conect to the phone..?

See here: https://librepilot.atlassian.net/wiki/display/LPDOC/LibrePilot2Go+Android+App

[ojik]

Can I add a barometer module to cc3d  atom with this version.

[D17E]

how to conect to the phone..?

See here: https://librepilot.atlassian.net/wiki/display/LPDOC/LibrePilot2Go+Android+App

if i dont have bluetooth modul for cc3d....thats mean i can not connect to the phone..? thats right..?

[hwh]

if i dont have bluetooth modul for cc3d....thats mean i can not connect to the phone..? thats right..?

If your phone supports USB OTG you can buy an USB OTG adapter and plug the cc3d into it.

[hwh]

Can I add a barometer module to cc3d  atom with this version.

No, cc3d does not support barometers and never will due to memory limitations.

[@marc]

if i dont have bluetooth modul for cc3d....thats mean i can not connect to the phone..? thats right..?

You can connect via USB, see here: https://librepilot.atlassian.net/wiki/display/LPDOC/LibrePilot2Go+Android+App#LibrePilot2GoAndroidApp-USB (basically the same page as above)

[D17E]

if i dont have bluetooth modul for cc3d....thats mean i can not connect to the phone..? thats right..?

If your phone supports USB OTG you can buy an USB OTG adapter and plug the cc3d into it.

thanks hwh...
i ll try soon.....

[tstrand]

I'm trying this release on my TBS discovery frame with Openpilot revolution FC and GPSv9 Platinum.
Seems to work well until switch from basic to INS13 - GPS Navigation and configure a couple of GPS flight modes.
Then the quad wants to flip over when i throttle up. I have done all the mag calibrations. and this worked well in the previous librepilot release.

[f5soh]

How is the Mag alarm while you apply Throttle ?

Please post your config file. File > Export UAV settings

[tstrand]

Did another Mag calibration. and now it seems to be working. all good.

[rotomoto]

just a summary how it looks from installation point of view

[D17E]

hi all..
anyone have video or make the video how to set and activate autotune..?
i still confuse here......

thanks...

[Tongala]

Just received my DJI gps (original), setup was a breeze on my Revo after following instructions from this forum.
Too wet and miserable outside to test however was able to get up to 10 sats inside on my coffee table.

This may or not relate to this RC but the GPS display gadget sky view does not show any satellites even though the gadget tells me the number of sats used and I have a 3D fix. Also all sensors green no alarms and Attitude Estimation Algorithm is set to GPS Navigation INS13.

Thanks