[Jackbear]

I am trying to set up the camera stabilization on my Revo board and it's not working. I followed all of the instructions posted by Painless 360, but no joy. The servo does creep a little when I power the board, and that's it. Any ideas?

[f5soh]

Hi, welcome.

Post your config file. File > Export UAV settings

Please note CC3D and Revolution boards are two different boards.
"Revolution" refers to a Chinese marketing name.

[TheOtherCliff]

I vaguely recall that it must be armed to actually stabilize the gimbal.  I may be wrong.

[Jackbear]

Here is the file. I armed the board in the GCS *I dont have my receiver yet*, but still no joy

[f5soh]

There a few things missing:

- Enable Gimbal module: go to Camstab tab, enable and power cycle.
- Define outputs, go to the vehicle tab and define each motor outputs or output module show a error (Red)
- Put some receiver channels as input or the INPUT module show a red alarm.

File attached is a working config from yours, should need to load a first time, reboot and load again.

The Gimbal works all time, no need to be armed.

[Jackbear]

It works perfect now!!!! Thank you so much!!! All of you guys help was greatly appreciated!

[f5soh]

Great