« previous next »
Pages: [1]
*

sigrana

  • *
  • 6
Revolution for octocopter H (H8)
« on: June 09, 2016, 05:40:14 am »
Hello all. I am going to build an H shaped octocopter for video filming and I am wondering if anyone knows how to setup a Revo for it or if the Revo can be used on such an octocopter configuration. Any comment would be appreciated. Thank you all in advance.
Logged
Theory is wonderful: every one understands it, but most of the time it does not work. Praxis, instead, always works but nobody understand why.
*

TheOtherCliff

  • *****
  • 4303
Re: Revolution for octocopter H (H8)
« Reply #1 on: June 19, 2016, 08:42:26 pm »
Normally there are only 6 outputs for motors so to make an octo, you will need to use the pwm inputs as outputs.  Configuration -> Hardware receiver port should be set to Outputs, and use Main or Flexi for a supported one wire RC protocol, like PPM, SBus, DSM...

Select an Octo type from the list in the Vehicle page.
Logged
Pages: [1]
« previous next »