Yes, I saved. It now saves PWM and receiver stat 100%...
It's a status, you can't save it. It's like trying to save the reading on your car speedometer.
It was meant for you to look at it and move the sticks, the readings should change as you move them. If they don't then you need to troubleshoot further.
Troubleshooting starts at the beginning, verify that the transmitter is talking to the receiver. Take the props off and connect one of the ESCs to the receiver. Verify that one of the sticks controls the speed of the motor properly. While you're at it you might as well verify all four sticks since it only takes a couple of seconds to move the cable.
If that works, next would be to verify how the receiver is wired to the cc3d. How is it wired?