ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« on: September 11, 2015, 09:27:23 am »
This is v7 of our constantly upgraded builds. But since we have added the PDB, Pro features are OSD, Pitch servo Gimbal, Buzzer, FPV Gears are so easy to add and setup we decided to call it Pro v1.

Meet Red Devil Pro v1 :

WST 1806 2300KV
HobbyWing X-Rotor 10 Amp
CC3D ATOM (Now lets see when we can install LP Firmware on this bad boy)
ZMR250 Frame
Fully integrated PDB (OSD ready, LC Filer for FPV Gears, LEDs)





« Last Edit: September 11, 2015, 09:32:27 am by ScratchBuilds »
Customer FPV Quad Studio
http://ScratchBuilds.com

Re: ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« Reply #1 on: September 11, 2015, 11:40:18 pm »
Nice!

Re: ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« Reply #2 on: September 14, 2015, 04:08:36 pm »
Thanks Mad. Next one I want to make ESCs plug and play. Searching for some 3 pin connectors that can handle min 10 Amp. Or will just go with JST to power ESC and single pin header type for signal.
Customer FPV Quad Studio
http://ScratchBuilds.com

ArnhemAnt

  • *
  • 147
Re: ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« Reply #3 on: September 16, 2015, 11:42:52 pm »
Lookin' real good. I'm certainly keeping an eye on the development of this frame.
If you do what you need, you’re surviving. If you do what you want, you’re living.

Daxo

  • ***
  • 123
Re: ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« Reply #4 on: September 25, 2015, 09:09:07 pm »
Very cool!
Innovation Matters

Re: ARF ZMR250 from ScratchBuilds.com aka Red Devil Pro v1
« Reply #5 on: September 30, 2015, 10:28:26 pm »
Very cool!
Lookin' real good. I'm certainly keeping an eye on the development of this frame.

Thanks guys. Here is quick update on what I have been working on.

LINK: https://drive.google.com/folderview?id=0B6H9KiLgiWqKQXYzaUY1d2NqZkU&usp=sharing
« Last Edit: September 30, 2015, 11:21:00 pm by ScratchBuilds »
Customer FPV Quad Studio
http://ScratchBuilds.com