[rubberducky]

Hey,
i connect a minimosd from rc timer with my cc3d reco board.
Before this, i updated the minimosd with the plain-cc3d hex file from version 15.02.
And then i flashed the character file to the osd.
Ok, it works.

But when ich choose a lot of parameter in the minimosd to see it in my display, i get only three or four parameter in my fpv display, so the virtual horizon or used sats.

Now i dont know where ist the problem, in the LP 15.09 firmware, in the settings of the GCS, or in the settings of the minimosd ?

Jürgen, Germany

[f5soh]

Your osd cannot fully work if you still use the 15.02 osd firmware with LP-15.09 CC3D firmware.

Go to wiki page and download last firmware, read comments in table for what you want:
https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup#MinOPOSDsetup-Downloadsdownloads

[rubberducky]

hi,
Thank you,
so i will try one of the files for the revoboard

LP_All_From_Revo1502.hex
(climb rate based on baro, no need GPS)
LP_All_From_Revo2303.hex (next)

It seems the latest version will be LP_All_From_Revo2303.hex

Jürgen

[f5soh]

1502 refers to date, not version.

Please test the last version i just uploaded today. Still compatible with older GCS versions.