Re: CC3D Support
« Reply #30 on: October 26, 2015, 05:19:14 pm »
Well just saying, altitude hold dun just have to be a strict position hold misnomer. I'd like to pull off rolls without dropping altitude or flying fpv and enjoy the view without having to worry about dropping height.

Zniggurat

  • *
  • 9
  • Sant'Ilario! °L°
    • B.F.C.T. YouTube Channel
Re: CC3D Support
« Reply #31 on: October 26, 2015, 05:30:55 pm »
...pull off rolls without dropping altitude...

Practice  ;)

...flying fpv and enjoy the view without having to worry about dropping height...

Revo  :P
Barely Flying Club Trento pilot

Wagsy

  • *
  • 87
    • Rotorpix
Re: CC3D Support
« Reply #32 on: October 26, 2015, 11:47:15 pm »
I have a REVO with one bank set to use ATTI and the on board BARO for emergency position hold if I loose VTX.
But, flying around with it on would be pointless.
Other banks are set on ACRO+

Learn to fly so you can fly around in ACRO+ or RATE modes.
I try out an auto level mode from time to time but it's just way to restrictive.

My other CC3D machines are set ACRO+ ACRO+ and 3rd bank to ATTI.
If I loose VTX up high I figure I can flick to ATTI and LOS fly it back if I can see it.
If not then I just crash it.

Once you can fly in a Manual mode, you will never fly in an Auto Level mode again.