Re: Need help setting up a OSD on a CC3D OpenPlilot
« Reply #15 on: April 20, 2016, 09:17:15 pm »
Hello Friends! I have some problem with my micro minimosd! I have CC3D+LibrePilot, after a did right like was in instructions and after i set my panel -
and that what i got -
why i see this many 0.0000?

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Need help setting up a OSD on a CC3D OpenPlilot
« Reply #16 on: April 20, 2016, 09:48:37 pm »
Hi, welcome.

The "temperature" object can be also be used for TxPID display with 3 values.
If you want to display temperature from Baro sensor, enter the setup screen (hit channel toggle just after boot) and you can set the TEMPDISP setting to temperature.

https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup#MinOPOSDsetup-RCOSDsetuprc_setup_screen

Re: Need help setting up a OSD on a CC3D OpenPlilot
« Reply #17 on: April 20, 2016, 10:15:33 pm »
Ok! because i don't have baro, i unmarked temp so now see voltage and current, but why i don't see may Name(Call Sign), and battery % is in mAh and it's goin from zero and going up...?

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Need help setting up a OSD on a CC3D OpenPlilot
« Reply #18 on: April 20, 2016, 10:41:28 pm »
Callsign is not supported.

About battery %, i think initially this info was based on voltage...
The mAh info increasing is the energy consumed.
If well calibrated, when you see 2000MAh with a 2200mAh battery you need to land quickly :)