[Paul-H]

Hi all

I have a CC3D board that I want to try in an Aeroplane for flight stabilization but need a little help

Its all connected and working but I cannot figure which Stabilization modes to use

With a normal plane flight controllers its common to use a 3 position switch and hand use that for off, gentle stab and full stab

With the CC3D I have manual for the first position but what about for the other two, I was thinking weak levelling for P2 and Attitude with max bank set to 45deg for P3 does that sound like a plane or is there  a better option.

Thanks for any help

Paul

[f5soh]

I prefer this settings:
- Attitude
- Rattitude
- Rate or Acro+

You can also consider the "Manual" mode that mean the board act like a pass through.