I've been messing with different settings and I'm just curious as to what you guys prefer using for flips and rolls.
It's a 250 size quad.
In rattitude, in the advanced menu I have...
Attitude Mode Response: Roll:55 Pitch:55 Yaw:35
Rate Mode Response: Roll:370 Ptich:370 Yaw:250
Max Rate Limit: Roll:310 Pitch:310 Yaw:300
I have my Roll Factor and Pitch Factor for Acro+ both on 70.
I want to make it flip quicker in Rattitude. With those settings it is doing a very slow flip and I have to be high in the air to do it. It makes a large circle with flipping.
In Rate, here are my settings:
Attitude Mode Response: Roll:57 Pitch:57 Yaw:35
Rate Mode Response: Roll:360 Ptich:360 Yaw:240
Max Rate Limit: Roll:330 Pitch:330 Yaw:330
I have my Roll Factor and Pitch Factor for Acro+ both on 40.
It flips super fast now with slight stick movement. I've gotten the hang of it where I can usually catch it nicely after a flip or double flip but I think it is still too fast for me. Sometimes I crash it especially when I am close to the ground. I want to slow it down and keep it flipping smoothly in rate.
------------------------------------------------------------------------------------------
Any advice or settings that you prefer?
You have to increase the Rate mode response (deg/s) to increase the flip/roll speed in Rattitude flight mode. I always use 700 deg/s for roll and pitch.
Max rate limit (all modes) (deg/s) should be equal or higher than Rate mode response.
Also, 240 deg/s for yaw seem a bit slow. You can safely use 360 deg/s at least.
If you like to fly with gyro only, then rate mode could be preferable for fpv race, whereas acro+ is the best choice for aerobatics.
You need different settings for rate and acro+.
If you use rate mode for fpv race you need a Rate mode response that is not too sluggish, tipically 400 deg/s should be ok. But you probably need some expo on your transmitter or in GCS to increase control and precision near center stick.
If you set acro+, then you can set a safe Rate mode response value, say 220-250 deg/s, so to have a very good control in normal flight. Then you have to set the AcroInsanityFactor (acro+ sliders in basic tab) to speed up flips and rolls without affect the near center stick behavior.