[Blake293]

Ian using libre pilot and trying to setup my motors for a minimum value. The problem i am having is channel 2 I have no spinning motor. I checked the voltage to all the channels. 1,3,4 read .21V. Channel 2 is reading .8V. Any suggestions. I jumps the other channels to esc/motor 2 and it works fine but the channel 2 signal is low on voltage. Any advice. Thanks 

[f5soh]

Please post your config file.
File > Export UAV settings.

Output 2 worked at some point ?

[TheOtherCliff]

You should make sure that on Output page your Bank(Channels) for channel 2 is set the same way as the others.  And of course that motor #2 output page looks about like the other motors on output page.

If that does not fix it, you can go to Vehicle page and set NE arm/motor to use output #5 instead of #2.  Save, move ESC connector from #2 to #5, reboot (maybe not needed), go to output page and set NE #5 up again.